Manta M8P V1.1 Bigtreetech Control Board For 3D Printer
In stock
₹6,299.00
In stock
Manta M8P V1.1 Bigtreetech Control Board For 3D Printer
Manta M8P V1.1 Bigtreetech Control Board For 3D Printer, running klipper with CB1 offers fully connected with their comprehensive interfaces, support filament runout detection, auto shutdown, BL touch, RGB lights…
- Connecting a filament runout detection sensor: Bigtreetech manta M8P V1.1 If the filament runs out, the mechanical sensor picks up the information and pauses the print, so you can resume later.
- Connecting an automatic shutdown module: Bigtreetech M8P V1.1 Automatically shut down after a print is finished to save power.
- CSI camera DSI display port: Bigtreetech M8P Work with a CS1 camera to capture your imagination. Work with a DSI display for interactive projects like tablets, entertainment systems.
Specifications:
- MCU: STM32G0B1VET6.
- Frequency: 64MHz.
- Driver Slot: 8.
- eFuse: √.
- Fan Port: 2 pins PWM Fan x 5 4pins PWM Fan x 2 Always on Fan x 1 SoC Fan x 1.
- Fan Voltage Selection (24V,12V.5V): √.
- Heater Cartridge Connector: 4.
- Thermistor: 100K NTC x 5.
- USB: 1 USB-OTG or UART to USB 3 USB- Host 2.0.
- HDMI: Micro HDMI x 2.
- 12C Interface: X.
- CAN bus Interface: √.
Package Include:
- 1 pcs of manta m8p V1.1.
| Weight | 1000 g |
|---|
Q & A
Ask a question
Your question will be answered by a store representative or other customers.
Thank you for the question!
Your question has been received and will be answered soon. Please do not submit the same question again.
Error
An error occurred when saving your question. Please report it to the website administrator. Additional information:
Add an answer
Thank you for the answer!
Your answer has been received and will be published soon. Please do not submit the same answer again.
Error
An error occurred when saving your answer. Please report it to the website administrator. Additional information:
Reviews
There are no reviews yet