BIGTREETECH Manta M5P BTT Control Board

BIGTREETECH Manta M5P BTT Control Board

• The BIGTREETECH Manta M5P BTT Control Board is a high-performance board designed to optimize the functionality and protection of your 3D printer.
• Powered by a 32Bit 64MHZ ARM Cortex-M0 Series-STM32G0B1RET6 chip, this board offers exceptional speed and reliability.
• One of the standout features of the Manta M5P is its compatibility with Marlin firmware without the need for CB1/CM4.
• This allows for seamless integration and easy setup. Additionally, the board supports 5-axis stepper motor drivers, providing enhanced control and precision.
• The Manta M5P is equipped with integrated SPI and UART modes of TMC driver and DIAG pin, which can be easily configured using jumpers.
• This flexibility allows for effortless customization and adaptation to your specific needs.
• The board also supports CAN Bus, allowing for simplified wiring and providing strong anti-interference capabilities.
• With onboard SPI interface and proximity switch port, the Manta M5P enables the connection of an acceleration sensor, enabling Klipper’s input shaping.

Features:

• Enhances the overall performance and accuracy of your 3D printer.
• The Manta M5P Board includes an eFuse circuit protection system.
• This system ensures that the board disconnects quickly in the event of an overload, reducing the risk of motherboard burnout caused by short circuits or ignition.
• The board also offers a screw reinforced installation option, adding stability and reliability to your setup.
• Integrated SPI and UART mode of TMC driver and DIAG pin, easily configurable with jumpers.
• Support filament runout sensor, BLTouch, RGB, etc.
• Replaceable fuse for easy maintenance.

Package Includes:

• 1 x Manta M5P Control Board.
• 1 x Type C USB Cable and accessories.